![]() ![]() ![]() Right mouse-click > Printing preferences > Advanced Setup > Media Type > set to Direct Thermal. Navigate to Contol Panel on your PC > Devices and Printers > Find the driver ZDesigner ZT2x0 > Refer to the article Configure or Modify Basic ZDesigner Driver Version 8 Settings. Right mouse-click > Printing preferences > Print Options > Printing mode > set to Direct Thermal. Navigate to Control Panel on your PC > Devices and Printers > Find the driver ZDesigner ZT2x0 > You may need to set the driver printing mode to Direct Thermal. If you set the printer into the Direct Thermal mode, removed the ribbon, and still face the Ribbon Out error, the printer driver is probably still in Thermal Transfer mode, where the ribbon is required.Ĭheck the driver settings. NOTE The driver settings always override printer settings. The ribbon out threshold (2) is likely too high, above the line that indicates where the ribbon is detected (1). Print a sensor profile (Refer to Print Information section).In Thermal Transfer Mode, the printer did not detect the ribbon even though it was loaded correctly. Refer to this article ZT200 Series Printers - Calibrating the Printer and Correcting Media Errors.Refer to ZT220 Manual Calibration Procedure.Refer to ZT230 Manual Calibration Procedure.Load printer defaults (see Load Defaults section) and perform Manual Calibration.Refer to this article: Video: Loading Ribbon and Resolving Ribbon Issues on ZT200 Series.The ribbon sensor is not detecting the ribbon.Refer to the following table for possible causes and recommendation solutions: The following lights signal the ' Ribbon Out' error: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |